×
First posts must be approved (25 Oct 2018)

Due to the unwelcome increase in the number of spam posts on the site it is now required for everyone's first post to be approved by a moderator.

Read More...

emo Aftermarket seats in a beat

More
05 May 2016 14:11 #26001

Hi everyone.

Im looking at getting a beat however the original zebra-print seats are worn on the drivers bolster and havent managed to find a decent replacement yet, anyone know of any low-profile racing seats that will fit and not look god awful?

Please Log in or Create an account to join the conversation.

More
05 May 2016 21:44 #26002

Please Log in or Create an account to join the conversation.

More
06 May 2016 10:51 #26003

most of the seats on honda beats are either worn or replaced already as the zebra fabric is very thin
also the driver and passenger side are a different width so bare that in mind
i did have a set redone in leather for about £300 at a place in swansea
if you want there info let me know and i will dig it out

Please Log in or Create an account to join the conversation.

More
06 May 2016 11:17 #26004

If you could ping me their Info Mikei that'd be great, plan B was going to be swapping the covers from a decent passenger side onto the drivers side as i did with my FTO, or alternatively replace them with some short bucket seats that would fit with the roof up.

I would no doubt end up running seat covers anyway but the Zebra print is kinda funky so for the purpose of shows e.t.c it'd be nice to have some good fabric underneath, I'm still negotiating with Japan for the car that i want so it isnt a definite yet but i do fancy some midship amusement for the summer.

Please Log in or Create an account to join the conversation.

More
15 May 2016 19:14 #26041

jack smiths of swansea for hoods and i think its his brother or in law at the same premises that done my seats
can sometimes be a mare to get hold of as they are a small family business but there work and prices are very good
tel no 01792 461022 you need to book well in advance

Please Log in or Create an account to join the conversation.

More
18 May 2016 13:12 #26048

You can also get just the bolsters re-upholstered in black (or grey?) leather - the two side wings of the back, and the u-shaped panels of the seat base. This retains nearly all of the zebra fabric, is cheaper than complete re-upholstery - and looks very cool.

Please Log in or Create an account to join the conversation.

More
18 May 2016 22:18 #26053

My GF had a set of zebra print pj's from tesco that were a near perfect match for the fabric for the seats, she wouldn't let me chop them up to repair mine though :)

Please Log in or Create an account to join the conversation.

Moderators: TADOAdam Kenneydazran
Time to create page: 0.253 seconds
Powered by Kunena Forum